CLI Guide

Switch Management Commands 2284
The stack member being connected to must be up and running and
connected as part of the stack.
This command is an alias for the exit command.
Example
(Example 1:
To disconnect a remote session to stack master established from a stack
member.
Unit 2 - CLI unavailable - please connect to master on Unit 1)>connect 1
Stack-Master#
Stack-Master#logout
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>
Example 2:
To disconnect a remote session to stack master established from a stack
member.
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>connect 1
Stack-Master#exit
Stack-Master>logout
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>
member
Use the member command in Stack Configuration mode to preconfigure a
switch stack member. Execute this command on the Management Switch. To
remove a stack-member configuration from the stack, use the no form of the
command.
The no form of the command may not be used if the member is present in the stack.
Syntax
member unit switchindex
no member unit
• unit — The switch identifier of the switch to be added or removed from
the stack. (Range: 1–12)
• switchindex — The index into the database of the supported switch
types, indicating the type of the switch being preconfigured. The switch
index is obtained from the show supported switchtype command.