CLI Guide

Table Of Contents
Switch Management Commands 2219
Default Configuration
The default configuration is 3 retries, and 15 seconds timeout. No hosts are
configured by default. No notifications are sent by default.
If you enter this command with no keywords, the default is to send all trap
types to the host in SNMPv1 format. No informs are sent to the host. If no
version keyword is present, the default is Version 1.
Command Mode
Global Configuration mode
User Guidelines
If a DNS host name is entered instead of an IP address, the switch attempts
to resolve the host name immediately using DNS. Use the ip domain-lookup
command and the ip name-server command to enable resolution of DNS
host names. Once resolved, the host name is not resolved again.
Command History
Added documentation updates in the 6.6.1 firmware release.
Example
The following example enables SNMP traps for host 192.16.12.143.
console(config)# snmp-server host 192.16.12.143 Dell EMC Networking traps
version 2
snmp-server location
Use the snmp-server location command in Global Configuration mode to set
the system location string. To remove the location string, use the no form of
this command.
Syntax
snmp-server location text
no snmp-server location
text — Character string describing the system location. (Range: 1 to 255
characters.)