CLI Guide

Switch Management Commands 2160
Default Configuration
Display of ICMP echo traces is disabled by default.
Command Mode
Privileged Exec mode.
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
Only IPv4 addresses are supported with the vrf parameter.
This command is only available on the N3000-ON/N3100 switches.
Debug output should be enabled with caution. Switch behavior may be
adversely affected by the additional processing load incurred from enabling
debug.
Example
The following example displays.
console#debug ping packet
debug rip
Use the debug rip command to enable tracing of RIP requests and responses.
Use the no form of this command to disable tracing of RIP requests and
responses.
Syntax
debug rip packet
no debug rip packet
Default Configuration
Display of RIP traces is disabled by default.
Command Mode
Privileged Exec mode.