CLI Guide

Switch Management Commands 2150
debug ip vrrp
To enable debug tracing of VRRP events, use the debug ip vrrp command in
Privileged Exec mode. To disable debug tracing, use the no form of the
command.
Syntax
debug ip vrrp
no debug ip vrrp
Default Configuration
No debug tracing is enabled by default.
Command Mode
Privileged Exec mode
User Guidelines
Debug messages are sent to the system log at the DEBUG severity level. To
print them on the console, enable console logging at the DEBUG level
(logging console debug).
The debug options enabled for a specific peer are the union of the options
enabled globally and the options enabled specifically for the peer.
Enabling one of the packet type options enables packet tracing in both the
inbound and outbound directions.
Command History
Command introduced in version 6.6 firmware.
debug ipv6 dhcp
Use the debug ipv6 dhcp command to display debug information about
DHCPv6 client activities and to trace DHCPv6 packets to and from the local
DHCPv6 client. To disable debugging, use the no form of the command.