CLI Guide

Switch Management Commands 2102
Example
This example enables Perpetual PoE.
console(config)#power inline poe-ha
power inline powered-device
The power inline powered-device command adds a comment or description
of the powered device type to enable the user to remember what is attached
to the interface. To remove the description, use the no form of this command.
Syntax
power inline powered-device pd-type
no power inline powered-device
• pd-type — Specifies the type of powered device attached to the
interface. (Range: 1–20 characters)
Command Mode
Interface Configuration (Ethernet).
User Guidelines
No specific guidelines.
Examples
console(config)#interface gigabitethernet 1/0/1
console(config-if-Gi1/0/1)# power inline powered-device IP-phone
power inline priority
The power inline priority command configures the port priority level, for the
delivery of power to an attached device. The switch may not be able to supply
power to all connected devices, so the port priority is used to determine which
ports will supply power if adequate power capacity is not available for all
enabled ports. For ports that have the same priority level, the lower-numbered
port has higher priority.