CLI Guide

Dell EMC Networking CLI 178
IPv6 Routing
show ip vlan Displays the VLAN routing information for all
VLANs with routing enabled.
PE
show route-map Displays the route maps. PE
show routing heap summary Displays a summary of the memory allocation
from the routing heap.
PE
a. For the meaning of each Mode abbreviation, see Mode Types .
Command Description Mode
a
arp Clears all entries in the IPv6 neighbor table
or an entry on a specific interface.
PE
clear ipv6 statistics Clears IPv6 statistics for all interfaces or for a
specific interface, including loopback and
tunnel interfaces.
PE
ipv6 address Configures an IPv6 address on an interface
(including tunnel and loopback interfaces).
IC
ipv6 enable Enables IPv6 routing on an interface
(including tunnel and loopback interfaces)
that has not been configured with an explicit
IPv6 address.
IC
ipv6 hop-limit Configures the hop limit used in IPv6 PDUs
originated by the router.
GC
ipv6 host Defines static host name-to-IPv6 address
mapping in the host cache.
GC
ipv6 mld last-member-
query-count
Sets the number of listener-specific queries
sent before the router assumes that there are
no local members on the interface.
IC (VC)
ipv6 mld last-member-
query-interval
Sets the last member query interval for the
MLD interface, which is the value of the
maximum response time parameter in the
group specific queries sent out of this
interface.
IC (VC)
ipv6 mld host-proxy Enables MLD Proxy on the router. IC
Command Description Mode
a