CLI Guide

Layer 3 Routing Commands 1533
ICMP Rate Limit Interval....................... 1000 msec
ICMP Rate Limit Burst Size..................... 100 messages
ICMP Echo Replies.............................. Enabled
ICMP Redirect Mode............................. Enabled
Maximum Next Hops.............................. 16
show ip interface
Use the show ip interface command to display information about one or
more IP interfaces. The output shows how each IP address was assigned.
Syntax
show ip interface [vrf vrf-name] [type number]
• vrf-name—The name of the VRF instance on which the command
operates. If no VRF parameter is given, information for the default
(global) router instance is shown.
• type—Interface type (loopback, out-of-band, or VLAN)
• number—Interface number. Valid only for loopback and VLAN types.
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec mode, Global Configuration mode and all
Configuration submodes
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
The VRF parameter is only available on the N3000-ON/N3100 series
switches.
The Method field contains one of the following values.
Field Description
DHCP The address is leased from a DHCP server.