Users Guide

Layer 2 Switching Commands 582
control list. To mitigate this behavior, permit rules must be added by the
operator to allow the appropriate control plane packets to ingress the CPU
(i.e., ARP, DHCP, LACP, STP BPDU, etc.). The control-plane keyword does
not filter traffic received over the out-of-band port.
Example
The following example attaches an IPv6 access control list to an interface.
console(config-if-Gi1/0/1)#ipv6 traffic-filter DELL_IP6 in
Command History
Syntax updated in the 6.4 release.
show ipv6 access-lists
Use the show ipv6 access-lists command in User Exec and Privileged Exec
mode to display an IPv6 access list and all of the rules that are defined for the
IPv6 ACL. Use the [
name ] parameter to identify a specific IPv6 ACL to
display.
Syntax
show ipv6 access-lists [ name ]
•
name — The name used to identify the IPv6 ACL.
Default Configuration
There is no default configuration for this command.
Command Mode
User Exec, Privileged Exec mode, Global Configuration mode and all
Configuration submodes
User Guidelines
There are no user guidelines for this command.
Example
console#show ipv6 access-lists
Current number of ACLs: 4 Maximum number of ACLs: 100