Users Guide

Switch Management Commands 2401
Default Configuration
This command has no default mode.
Command Mode
Global Configuration mode
User Guidelines
If no stack configuration appears in the saved config, it is built at runtime and
appears in the running config. The operator can save the stack configuration.
Switches that do not match the saved config (are of a different type than as
configured) after a reboot will show a config mismatch and do not join the
stack. Units that do not join the stack will show their interfaces as detached.
Example
The following example sets the console command mode to Stack Config.
console(config)#stack
console(config-stack)#
stack-port
Use the stack-port command in Stack Configuration mode to configure ports
as either Stacking ports or as Ethernet ports.
NOTE: This command is only valid on the N1100-ON, N1500, N2100-ON, N2200-ON,
N3100-ON, and N3200-ON switches. It issues an error response if used on any other
switch model.
Syntax
stack-port {fiftygigabitethernet | fortygigabitethernet |
twentyfivegigabitethernet| twentygigabitethernet|tengigabitethernet}
unit/slot/port {ethernet | stack [speed { 40g | 21g }]}
• speed {40g|21g}—Set the stack port speed. The speed parameter is only
available on the Dell EMC Networking N2100/N3100-ON Series
switches.