Users Guide

Switch Management Commands 2328
Syntax
clear counters stack-ports
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode
User Guidelines
This command resets all statistics shown by the show switch stack-ports
counters and the show switch stack-ports diag commands.
Example
console#clear counters stack-ports
connect
Use this command to connect the serial console of a different stack member
to the local unit. The connect command allows administrations that deploy
terminal servers to connect a single serial line to any stack member for
administration of the stack via the console. The network administrator can
use the connect command to access the primary unit console session when
presented with a “CLI unavailable message” due to a primary switchover.
Syntax
connect unit
• unit —A unit number in the stack.
Default Configuration
There is no default configuration for this command.
Command Modes
Privileged Exec mode on management unit in the stack.
Unit Prompt on stack member.