Users Guide

Dell EMC Networking CLI 199
maximum-paths Sets the number of paths that OSPF can report
for a given destination.
ROSV3
nsf Enables OSPF graceful restart. ROSV3
nsf helper Allows OSPF to act as a helpful neighbor for a
restarting router.
ROSV3
nsf helper strict-lsa-
checking
Requires that an OSPF helpful neighbor exit
helper mode whenever a topology change occurs.
ROSV3
nsf restart-interval Configures the length of the grace period on the
restarting router.
ROSV3
passive-interface Sets the interface or tunnel as passive. IC
passive-interface default Enables the global passive mode by default for all
interfaces.
ROSV3
redistribute (OSPFv3) Configures the OSPFv3 protocol to allow
redistribution of routes from the specified source
protocol/routers.
ROSV3
router-id Sets a 4-digit dotted-decimal number uniquely
identifying the Router OSPF ID.
ROSV3
show ipv6 ospf Displays information relevant to the OSPF
router.
UE, PE,
GC,
VRC
show ipv6 ospf abr Displays the internal OSPFv3 routes to reach
Area Border Routers (ABR).
PE,
VRC
show ipv6 ospf area Displays information about the area. PE,
VRC
show ipv6 ospf asbr Displays the internal OSPFv3 routes to reach
Autonomous System Boundary Routes (ASBR).
PE,
VRC
show ipv6 ospf border-
routers
Displays internal OSPFv3 routers to reach Area
Border Routers (ABR) and Autonomous System
Boundary Routers (ASBR).
UE or
PE, or
VRC
show ipv6 ospf database Displays information about the link state
database when OSPFv3 is enabled.
PE,
VRC
Command Description Mode
a