Manualshelf

Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsEMC PowerSwitch N3100 Series
1941194219431944194519461947194819491950
Table Of Contents
Switch Management Commands 1946
Command Mode
Global Configuration mode
User Guidelines
If a user enters a value which is not an exact power of two, the nearest power-
of-two value is applied.
Example
The following example sets the polling time for the Simple Network Time
Protocol (SNTP) client to 1024 seconds.
console(config)# sntp client poll timer 1024
sntp server
Use the sntp server command in Global Configuration mode to configure an
SNTP server address or a host name. The server address can be either an IPv4
address or an IPv6 address. Use the no form of this command to unconfigure
an SNTP server address or a host name.
Syntax
sntp server {
ip-address
|
ipv6-address
|
hostname
}
no sntp server {
ip-address
|
ipv6-address
|
hostname
}
•
ip-address
— IP address of the server.
•
hostname —
Hostname of the server. (Range: 1-158 characters)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
2CSNXXX_SWUM204.book Page 1946 Monday, January 25, 2016 1:25 PM