Administrator Guide

Layer 3 Routing Commands 1342
Command History
Introduced in version 6.3.0.1 firmware.
Example
console#show bgp ipv6 listen range
Listen Range .................................. 2001::1/64
Inherited Template ............................ template_2001
Member ASN State
--------------------------------------- ----- -----------
2001::10 65001 OPENCONFIRM
2001::20 0 ACTIVE
Listen Range .................................. 2002::1/64
Inherited Template ............................ template_2002
Member ASN State
--------------------------------------- ----- -----------
show bgp ipv6 neighbors
Use this command to display neighbors with IPv4 or IPv6 peer addresses that
are enabled for the exchange of IPv6 prefixes. This command deprecates and
replaces the show ipv6 bgp neighbors command.
Syntax
show bgp ipv6 neighbors [ ipv4-address | ipv6-address [ interface interface-
id
] | autodetect interface interface-id ]
• ipv4-address | ipv6-address —(Optional) If a peer address is specified, the
output is limited to an individual peer.
•
interface-id —(Optional) If the peer address is an IPv6 link local address,
the interface that defines the scope of the link local address must be given.
This must be a VLAN routing interface.
•
autodetect interface interface-id —(Optional) The routing interface on
which the neighbor’s link local IPv6 address is auto detected.
2CSNXXX_SWUM204.book Page 1342 Monday, January 25, 2016 1:25 PM