Administrator Guide

Authentication, Authorization, and Accounting 311
Equal Access to External Network " on page 1467, describes how to
configure a policy named internet_access.
If you use an authentication server to assign DiffServ policies to an
authenticated user, note the following guidelines:
• If the policy specified within the server Filter-id attribute does not exist on
the switch, authentication will fail.
• Do not delete policies used as the Filter-id by the RADIUS server while
802.1X is enabled.
• Do not use the DiffServ
service-policy command to apply the filter to an
interface if you configure the RADIUS server or 802.1X authenticator to
assign the DiffServ filter.
In the following example, Company XYZ uses IEEE 802.1X to authenticate
all users. Contractors and temporary employees at Company XYZ are not
permitted to have access to SSH ports, and data rates for Web traffic is
limited. When a contractor is authenticated by the RADIUS server, the server
assigns a DiffServ policy to control the traffic restrictions.
The network administrator configures two DiffServ classes:
cl-ssh and cl-http .
The class
cl-ssh matches all incoming SSH packets. The class cl-http matches
all incoming HTTP packets. Then, the administrator configures a traffic
policy called
con-pol and adds the cl-ssh and cl-http . The policy is configured
so that SSH packets are to be dropped, and HTTP data rates are limited to 1
MB with a burst size of 64 Kbps. HTTP traffic that exceeds the limit is
dropped.
The host ports, ports 1–23, are configured to use MAC-based dot1x
authentication to allow the DiffServ policy to be applied. Finally,
the
administrator configures the RADIUS server with the attribute
Filter-id (11)=
“con-pol” (steps not shown).
To configure the switch:
1
Configure the DiffServ traffic class that matches SSH traffic.
console#configure
console(config)#class-map match-all cl-ssh
console(config-classmap)#match dstl4port 22
console(config-classmap)#exit
2 Configure the DiffServ traffic class that matches HTTP traffic.
console(config)#class-map match-all cl-http
console(config-classmap)#match dstl4port 80
console(config-classmap)#exit