Administrator Guide
Stacking 261
The following is the output on Dell EMC Networking N1500 Series
switches:
console#show supported switchtype
SID Switch Model ID
--- --------------------------------
1 N1524
2 N1524P
3 N1548
4 N1548P
2
Preconfigure the switch (SID = 2) as member number 2 in the stack.
console#configure
console(config)#stack
console(config-stack)#member 2 2
console(config-stack)#exit
console(config)#exit
3
Confirm the stack configuration. Some of the fields have been omitted
from the following output due to space limitations.
console#show switch
Management Standby Preconfig Plugged-in Switch Code
SW Status Status Model ID Model ID Status Version
-- ------ ------ -------- -------- ------ -------
1 Mgmt Sw N3048 N3048 OK 6.0.0.0
Pre-configured switches may be removed from the configuration using the no
member command. Only switches that are not active members of the stack
may be removed.