Users Guide

Switch Management Commands 2035
hardware-address
Use the hardware-address command in DHCP Pool Configuration mode to
specify the MAC address of a client to be manually assigned an address. Use
the no form of the command to remove the MAC address assignment.
Syntax
hardware-address hardware-address
no hardware-address
•
hardware-address —MAC address of the client. Either the
XXXX.XXXX.XXXX or XX:XX:XX:XX:XX:XX form of MAC address may
be used where X is a hexadecimal digit.
Default Configuration
There are no default MAC address manual bindings.
Command Mode
DHCP Pool Configuration mode
User Guidelines
Use the show ip dhcp pool command to display pool configuration
parameters. It may be necessary to use the no host command prior to
executing the no hardware-address command.
Example
console(config-dhcp-pool)#hardware-address 00:23:12:43:23:54
console(config-dhcp-pool)#host 192.168.21.131 32
host
Use the host command in DHCP Pool Configuration mode to specify a
manual binding for a DHCP client host. Use the no form of the command to
remove the manual binding.
Syntax
host ip-address [netmask|prefix-length]