Users Guide

Layer 3 Routing Commands 1566
Example
The following shows example CLI display output for the command.
console# show ip protocols
Routing Protocol.......................... BGP
Router ID................................. 6.6.6.6
Local AS Number........................... 65001
BGP Admin Mode............................ Enable
Maximum Paths............................. Internal 32, External 32
Distance.................................. Ext 20 Int 200 Local 200
Address Wildcard Distance Pfx List
------- -------- -------- --------
172.20.0.0 0.0.255.255 40 None
172.21.0.0 0.0.255.255 45 1
Prefix List In............................ PfxList1
Prefix List Out........................... None
Neighbors:
172.20.1.100
Filter List In........................ 1
Filter List Out....................... 2
Prefix List In........................ PfxList2
Prefix List Out....................... PfxList3
Route Map In.......................... rmapUp
Route Map Out......................... rmapDown
172.20.5.1
Prefix List Out....................... PfxList12
Routing Protocol.......................... OSPFv2
Router ID................................. 6.6.6.6
OSPF Admin Mode........................... Enable
Maximum Paths............................. 32
Routing for Networks...................... 172.24.0.0 0.0.255.255 area 0
10.0.0.0 0.255.255.255 area 1
Default Metric The metric assigned to redistributed routes.
Default Route
Advertise
Whether this router is originating a default route.
Distance The administrative distance for RIP routes.
Interface The interfaces where RIP is enabled and the version sent and
accepted on each interface.
Parameter Description