Users Guide

Security Commands 1007
no dot1x timeout tx-period
• seconds — Time in seconds that the switch should wait for a response to
an EAP-Request/Identity frame from the client before resending the
request. (Range: 1–65535)
Default Configuration
The period of time is set to 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Change the default value of this command only to adjust for unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.
Example
The following command sets the number of seconds that the switch waits for
a response to an EAP-request/identity frame to 3600 seconds.
console(config)# interface gigabitethernet 1/0/16
console(config-if-Gi1/0/16)# dot1x timeout tx-period 3600
auth-type
Use this command to set the accepted authorization types for dynamic
RADIUS clients. Use the no form of the command to set the authorization
type to the default (all).
Syntax
auth-type { all | any |session-key}
no auth-type
• all—Selects all COA client authentication types. All session identification
attributes must match for the authentication to succeed.
• any—Selects any COA client authentication type. Any session
identification attribute may match for the authentication to succeed.