Users Guide

● Headroom — The difference between rack power capacity (specified by the user when the rack is added to OpenManage
Power Center system) and rack power consumption (determined by the actual power consumption by PDUs added or
associated with the rack).
● Demand — Amount of power a device requests to accommodate its workload.
● Estimated maximum power (Estimated max power) — The maximum power consumption allocation estimated for a
device. The estimated max power is considered the peak power consumption by a device.
Dynamic power caps enable all devices to execute workloads without requiring more power than the overall power cap assigned
to the group. When choosing a dynamic power cap, remember:
● If lower-priority devices require more power to maintain their cap, they may receive more power than higher-priority devices.
● If the power cap is too restrictive and the group power consumption exceeds the power cap, an error event occurs for the
policy. If this occurs frequently, reconsider your power allocations, or adjust workloads accordingly.
● If fluctuations in device power requirements occur after the power cap is successfully established, then a device that
requires more power may not receive it if the power cap of another device in the policy would be violated. To force one or
more devices in a policy to a lower cap, create a static power policy for the device at a lower level (rack or chassis). The
most restrictive power cap of the overlapping policies is applied to the device.
● If there is excess available power (known as headroom) after all power capping requirements are met, the excess power is
dynamically allocated according to the priority and demand of each device in the power policy.
Power Policy Capabilities
Power Center defines the following statuses of power policy capabilities for the devices:
● Unknown — Shown for unsupported devices or devices that were never connected to Power Center.
● None — No power policy capability. You cannot set any policy on the device.
● Monitor — With power monitoring capability only.
● Monitor & Capping — With power monitoring and capping capabilities.
● Monitor and Upgradable — With power monitoring capability, and can be upgraded to have power capping capability.
You can find this power policy capability status in the Power Capability column of the Devices page.
For servers that comply with iDRAC7, when there is a power policy capability change due to a license change, Power Center
changes its information in the management console within 24 hours. There are two scenarios:
Scenario 1 — The license expires or is not imported
In this case, the following happens:
● If a policy exists on the devices, a "Server Capabilities Changed" event is generated.
● The Policies tab of the devices is set to disabled in the Groups page.
● The power capability status of the devices is set to "None" in the Devices page.
● You cannot edit the policy of this device from the Policies page; you can only delete it.
Scenario 2 — You try to import a license on a device without a license
imported
In this case, the following happens:
● If a policy exists on the devices, a "Server Capabilities Changed" event is generated.
● The Policies tab of the devices is set to Enabled in the Groups page.
Policies
75