Users Guide

Uninstalling Power Center in Linux

NOTE: Ensure to remove all devices from the OpenManage Power Center console before uninstalling Power Center.

Otherwise, the existing power cap value set in the policies (including EPR) will remain effective on the devices. Ensure to

check your data center power capacity before removing the devices to avoid tripping the breaker, because the policies are

also removed at the same time.

To uninstall Power Center on a Linux server, type the following at the command line interface:

rpm –e OpenManage_PowerCenter

NOTE: On uninstalling OpenManage Power Center, the installation folder where OpenManage Power Center is installed, is

removed.

Launching Power Center in Linux

Open a Web browser. You may need to configure your Web browser to launch OpenManage Power Center.

To launch OpenManage Power Center, enter the following address in lower case in your Web browser:

For example: https://localhost:8643/

NOTE: It is recommended to use screen resolutions of 1280*800 pixels or higher for using the OpenManage Power Center

management console.

Select a user account and enter your name and password. The OpenManage Power Center console is displayed. You can use the

OpenManage Power Center functions.

Using OpenManage Power Center