Users Guide

nd_device
Usage:
ompc_cli find_device [-service_tag <stag>] [<device_name>]
The find_device command is used to list all groups' name (fully qualied) the device identied by service tag or device_name belongs
to.
service_tag command option is supported.
remove_prole
Usage:
ompc_cli remove_profile <profile-name>
The remove_prole command removes a discovery prole.
delete_device
Usage:
ompc_cli delete_device [-service_tag <stag>] [<device_name>]
The delete_device command deletes a device. You cannot use –service_tag and device_name at the same time.
If the device is a chassis, it is deleted like a group (if the blades in it are already enumerated). The chassis itself is also deleted from OMPC,
and is no longer visible on the Devices page.
add_group
Usage:
ompc_cli add_group [-description <description>] -group_type <DC|ROOM|AISLE|RACK|CUSTOM > [-
capacity <capacity>] [-total_power_capacity <power_capacity>] GROUP_PATH
The add_group command adds a new group identied by GROUP_PATH. If the type is RACK, you must supply the <capacity> option.
Forward slash (/) cannot be used as GROUP_PATH in the add_group command.
The chassis can be added to any group at any time. You can only add Chassis Management Console (CMC) to one rack; not multiple racks.
When you add CMC to any group, the blades inside it can be enumerated.
delete_group
Usage:
ompc_cli delete_group [-preview] GROUP_PATH
Using OpenManage Power Center through Command Line Interface
35