Release Notes
Fixes
Issue 1:
Description: In "Dell EMC Server Overall Health Status" service, Power Supply Roll up status would be shown as UNKNOWN even if the
actual Power supply Roll up status is OK after upgrading iDRAC rmware to 2.30.30.30 or a higher version when Dell server is discovered
using WSMan. The actual status will be shown correctly once there is any change in the health status of the Power supply.
Issue 2:
Description: In "Dell EMC Server Voltage Probe Status", service when one of the instance's actual status is UNKNOWN, that instance will
appear as CRITICAL instead of UNKNOWN while monitoring using SNMP protocol with iDRAC rmware version lower than 2.30.30.30.
Issue 3:
Description: In "Dell EMC Server Voltage Probe Status" service, some of the Voltage instances will be missing when PowerEdge C6320
server is discovered using WSMan protocol with iDRAC rmware version lower than 2.30.30.30.
Issue 4:
Description: In "Dell EMC Server Overall Health Status" service, Power Supply Status is shown as OK instead of UNKNOWN, when
PowerEdge T130 or PowerEdge C6320 server is discovered using SNMP protocol, and when PowerEdge DSS1510 server is discovered
using SNMP or WSMan protocol with iDRAC rmware version lower than 2.30.30.30.
Issue 5:
Description: Dell EMC Warranty Status showing Critical if initial warranty is expired, but extended warranty still exists.
Issue 6:
Description: If a Dell EMC Chassis is congured with only Internet Protocol Version 6 (IPv6) address and is not using the HTTPS default
port number (default 443) and was discovered using the Host Name, then the users will not be able to access Chassis Management
Controller (CMC) web interface from the Nagios XI console.
3
Fixes 7