Install Guide

Table 2. Supported firmware versions for Dell EMC devices (continued)

Dell EMC Device Firmware Supported Firmware Versions

13th generation of PowerEdge servers iDRAC8 2.50.50.50 and 2.41.40.40

12th generation of PowerEdge servers iDRAC7 2.50.50.50 and 2.41.40.40

Datacenter Scalable Solutions iDRAC8 2.50.50.50 and 2.41.40.40

Nutanix XC iDRAC8

iDRAC9

2.50.50.50 and 2.41.40.40

3.15.15.15 and 3.11.11.11

VxRail iDRAC8

iDRAC9

2.50.50.50 and 2.41.40.40

3.15.15.15 and 3.11.11.11

PowerEdge M1000e Chassis CMC 6.0 and 5.22

PowerEdge VRTX Chassis CMC 3.0 and 2.23

PowerEdge FX2/FX2s Chassis CMC 2.0 and 1.42

Compellent SC-Series Storage Arrays NA 7.2.10 and 7.2.1

EqualLogic PS-Series Storage Arrays NA 9.1.5 and 9.1.4

PowerVault MD 34/38 Series Storage Arrays NA 08.25.13.60 and 08.25.11.60

Dell EMC Network Switches M, S, FN, Z and C-Series

Dell EMC Network Switches N-Series

9.13.0.0 and 9.11.2.8

6.3.3.10 and 6.3.3.9

• If you are using SNMP protocol, ensure that SNMP is configured in the respective devices.

If you want to receive SNMP traps in the Nagios Core console, ensure that you configure the SNMP trap destination in the respective

devices.

For more information, see Appendix in the Dell EMC OpenManage Plug-in Version 3.0 for Nagios Core User’s Guide at dell.com/

omconnectionsEnterpriseSystemsManagement.

• If you are using Redfish REST APIs, ensure that Redfish is enabled in the respective devices.

• If you are using WSMan protocol, it is recommended that you use a WSMan service account other than the default service account.

For more information, see Configuring User Accounts and Privileges in the respective device’s User’s Guide at Dell.com/

esmmanuals.

For the list of supported platforms, see Support Matrix in the Dell EMC OpenManage Plug-in Version 3.0 for Nagios Core User’s Guide.

System requirements