Users Guide
Table Of Contents
- Dell EMC OpenManage Plug-in Version 3.0 For Nagios XI User’s Guide
- Introduction
- What is new in Dell EMC OpenManage Plug-in version 3.0
- Key features
- Support matrix
- Dell EMC Configuration Wizard
- Device discovery using the Dell configuration wizard
- Viewing Dell EMC devices
- Monitoring Dell EMC devices
- Launching Dell EMC device consoles
- Warranty information for Dell EMC devices
- Knowledge Base information for the generated alerts
- Removing Dell EMC devices or services
- Troubleshooting
- Frequently asked questions
- Appendix
- Related documentation and resources
Device discovery using the Dell configuration
wizard
The following sections describe the process of discovering Dell devices and their associated services using the Dell monitoring
wizard. Once you complete all the configuration steps successfully, the hosts and their corresponding services will be available
for monitoring in the Nagios XI console.
Before you begin, ensure that all the prerequisites are installed in your system based on your monitoring requirements. For
more information about the prerequisites, see the section System requirements for management systems in the Dell
OpenManage Plug-in for Nagios XI Installation Guide.
Topics:
• Configuration Wizard - Dell EMC OpenManage Plug-in for Nagios XI - Step 1
• Configuration Wizard - Dell EMC OpenManage Plug-in for Nagios XI - Step 2
• Configuration Wizard - Dell EMC OpenManage Plug-in for Nagios XI - Step 3
Configuration Wizard - Dell EMC OpenManage Plug-in
for Nagios XI - Step 1
You can configure the various parameters for discovery of devices using the Dell EMC OpenManage Plug-in such as target IPs,
protocol parameters, warranty, and other configurations parameters.
Ensure that you provide only positive integer values when numeric values are required. For more information, see Dell EMC
configuration wizard discovery parameters.
If you encounter any errors while performing any of the following steps, ensure that you fix them before proceeding.
1. To open the Dell EMC plug-in, under the Configure tab, select Configuration Wizards and then click Dell EMC
OpenManage Plug-in for Nagios XI.
The Configuration Wizard: Dell EMC OpenManage Plug-in for Nagios XI - Step 1 page is displayed along with the
overview of the plug-in and the summary of the prerequisite check.
2. Under the Discovery Target menu, select any of the following discovery options:
● Auto-Discovery Jobs - Select an existing Auto discovery job from the drop down menu.
● Subnet - Select to discover devices using a subnet with mask.
● File - Select to discover a list of devices using a file.
3. In the Communication Parameters table, provide appropriate values.
4. In the Configuration Parameters table, enter appropriate values based on your monitoring requirement, and then click
Next.
6
18 Device discovery using the Dell configuration wizard