Release Notes
Table Of Contents
- Dell EMC OpenManage Plug-in Version 3.1 for Nagios Core Release Notes
- Release Type and Definition
- What is new
- Fixes
- Important Notes
- Known Issues
- Limitations
- Installation Prerequisites
- Installation Instructions
- Installation and Configuration Notes
- Accessing documents from the Dell EMC support site
- Contacting Dell
Launch the respective chassis console for the PowerEdge M1000e, PowerEdge VRTX, and PowerEdge FX2/FX2s chassis host from the
Nagios Core to view the the health status of standby power supply.
Issue 6(93599):
Description:
In "Dell EMC Server Controller Status" service, an extra instance will be shown only when Dell EMC PowerEdge server is been discovered
using RedFish protocol and that device have SATA controller
Version Affected:
Version 3.1
Resolution:
Launch the respective chassis console for the PowerEdge M1000e, PowerEdge VRTX, and PowerEdge FX2/FX2s chassis host from the
Nagios Core to view the the health status of standby power supply.
Issue 7(98517):
Description:
Discovery of Dell EMC PowerEdge Server (Rack and Cloud) with firmware versions between 3.00.00.00 and 3.15.15.15 using IPv6 with
WSMan or RedFish protocol will fail.
Version Affected:
Version 3.1
Issue 8(155276):
Description:
OMSDK installation may fail with pip version 10.0 and above
Version Affected:
Version 3.1
Resolution:
Follow any one of the below steps:
• Downgrade pip version to lower than 10.0 and then install omsdk
• Force install omsdk using: pip install --ignore-installed omsdk
Issue 9(156443):
Description:
ME4 Alert with Event 198 is shown as Normal/Informational instead of Critical.
Version Affected:
Version 3.1
Known Issues
9