Install Guide

Table 3. Supported firmware versions for PowerEdge Chassis
Dell EMC PowerEdge Chassis CMC versions
PowerEdge M1000e Chassis
6.1 and later versions
PowerEdge MX7000 modular chassis
1.1 and later versions
PowerEdge VRTX chassis
3.2 and later versions
PowerEdge FX2/FX2s chassis
2.2 and later versions
Table 4. Supported firmware versions for Storage
Dell EMC Storage Arrays Supported Firmware versions
Dell Compellent SC-Series Storage Arrays
7.2.1 and later versions
EqualLogic PS-Series Storage Arrays
9.1.4 and later versions
PowerVault MD 34/38 Series Storage Arrays
08.25.11.60 and later versions
PowerVault ME4 Storage Arrays
GT275R005-04 and later versions
Table 5. Supported firmware versions for Network switches
Dell EMC Operating System based Network switches Supported firmware versions
Operating System 6
6.6.0.13 and later versions
Operating System 9
19.4.1.8 and later versions
Operating System 10
10.5.1.0 and later versions
NOTE: iDRAC versions are not applicable for Storage and network switches.
• If you are using SNMP protocol, ensure that SNMP is configured in the respective devices.
If you want to receive SNMP traps in the Nagios Core console, ensure that you configure the SNMP trap destination in the respective
devices.
For more information, see Appendix in the Dell EMC OpenManage Plug-in Version 3.1 for Nagios Core Users Guide at dell.com/
omconnectionsEnterpriseSystemsManagement.
• If you are using WSMan protocol, it is recommended that you use a WSMan service account other than the default service account.
For more information, see Configuring User Accounts and Privileges in the respective device’s User’s Guide at Dell.com/
esmmanuals.
For the list of supported platforms, see Support Matrix in the Dell EMC OpenManage Plug-in Version 3.1 for Nagios Core User’ Guide.
System requirements
7