Users Guide
Table Of Contents
- Dell EMC OpenManage Plug-in Version 2.1 for Nagios Core User’s Guide
- Contents
- Introduction to Dell EMC OpenManage Plug-in Version 2.1 for Nagios Core
- What is new in Dell EMC OpenManage Plug-in version 2.1
- Key features
- Support matrix
- Device discovery and inventory
- Monitor Dell EMC devices
- Launching Dell EMC device specific consoles
- Warranty information for Dell EMC devices
- Removing Dell EMC devices
- Knowledge Base (KB) messages for the generated alerts
- Troubleshooting
- Frequently asked questions
- Appendix
Table 28. Dell trap information
Service Status Description
● Critical
Dell EMC Storage MD-Series Traps The following states are possible:
● OK
● Warning
● Unknown
● Critical
Provides trap Information of the
PowerVault MD-Series storage arrays.
Viewing SNMP alerts
Prerequisites:
● Nagios Core with SNMPTT is installed and configured and the Dell integration on SNMPTT is configured.
● SNMP Trap destination is configured with Nagios Core server in the supported Dell EMC devices.
NOTE: To receive SNMP traps from PowerVault MD 34/38 series storage arrays, SNMP trap destination must be
configured for that device in the Modular Disk Storage Manager (MDSM) console.
For information on configuring SNMP Trap destination in the iDRAC interface, see Appendix.
To view SNMP alerts:
In Nagios Core user interface, under Current Status, select Services and then navigate to the respective Dell EMC device
specific trap service.
Displays the last received SNMP alert in the status information and the severity of the alert is updated in the status. To view all
the SNMP alerts that were received, select Reports > Alerts > History.
Monitor Dell EMC devices
33