Users Guide

● If you run the Python command python dellemc_nagios_discovery_service_utility.py without the --all
option, then only the basic services are created by default and displayed in the user interface under Services.
NOTE: SNMPTT must be configured for you to be able to receive traps.
● If you run python dellemc_nagios_discovery_service_utility.py with the --all option, detailed services
are created as listed in the table below, and are displayed in the Nagios Core console under Services:
Table 16. Default services created for Dell EMC Servers based on the selected protocol
Services SNMP WSMan Protocol Redfish Protocol
Basic Services
Dell EMC Server Overall Health
Status
√ √ √
Dell EMC Server Information √ √ √
Dell EMC Server Traps √ √ √
Detailed Services
Dell EMC Memory Status √ √ √
Dell EMC Server Physical Disk
Status √ √ √
Dell EMC Server Disk Group
Status √ √ √
Dell EMC Server Fan Status √ √ √
Dell EMC Server Battery Status √ √ X
Dell EMC Server Intrusion
Status
√ √ X
Dell EMC Server Network
Device Status
√ √ √
Dell EMC Server Voltage Probe
Status
√ √ √
Dell EMC Server Controller
Status
√ √ √
Dell EMC Server Amperage
Probe Status
√ √ X
Dell EMC Server CPU Status √ √ √
Dell EMC Server Power Supply
Status
√ √ √
Dell EMC Server Temperature
Probe Status
√ √ √
Dell EMC Server SD Card
Status
X √ √
Dell EMC Server FC NIC Status X √ √
Dell EMC Server Warranty
Information
√ √ √
Dell EMC Server GPU and
General Purpose GPUs
X X √
NOTE: Redfish protocol supports iDRAC firmware version 3.30.30.30 and above.
Table 17. Default services created for all Dell EMC Chassis based on WSMan protocol
18 Device discovery and inventory