Setup Guide

System requirements for managed systems
The requirements for the managed systems are as follows:
Table 2. Supported firmware versions for Dell EMC devices
Dell EMC Device Firmware Supported Firmware Versions
12th generation of PowerEdge servers iDRAC7 2.41.40.40 and 2.40.40.40
13th generation of PowerEdge servers iDRAC8 2.41.40.40 and 2.40.40.40
14th generation of PowerEdge servers iDRAC9 3.00.00.00
Datacenter Scalable Solutions iDRAC8 2.41.40.40 and 2.40.40.40
HCI Platforms iDRAC8 2.41.40.40 and 2.40.40.40
PowerEdge M1000e Chassis CMC 5.22 and 5.21
PowerEdge VRTX Chassis CMC 2.23 and 2.22
PowerEdge FX2/FX2s Chassis CMC 1.42 and 1.41
Compellent Storage Arrays NA 7.1.12 and 6.7.40
EqualLogic PS-Series Storage Arrays NA 9.1.2 and 9.1.1
PowerVault MD 34/38 Series Storage Arrays NA 08.25.11.60 and 08.25.09.61
● If you are using SNMP, ensure that SNMP is configured in the respective devices.
If you want to receive SNMP traps in the Nagios Core console, ensure that you configure the SNMP trap destination in the
respective devices.
For more information, see Appendix in the Dell EMC OpenManage Plug-in Version 2.1 for Nagios Core User’s Guide at
dell.com/omconnectionsEnterpriseSystemsManagement.
● If you are using WSMan protocol, it is recommended that you use a WSMan service account other than the default service
account. For more information, see Configuring User Accounts and Privileges in the respective device’s User’s Guide at
Dell.com/esmmanuals.
For the list of supported platforms, see Support Matrix in the Dell EMC OpenManage Plug-in Version 2.1 for Nagios Core
User’s Guide.
System requirements
7