Users Guide
Table Of Contents
- Dell OpenManage plug-in versione 2,0 per Nagios Core Guida dell'utente
- Sommario
- Introduzione a Dell OpenManage plug-in versione 2,0 per Nagios Core
- Quali sono le novità di Dell SPI versione 4,0
- Funzioni principali
- Matrice di supporto
- Discovery e inventario del Device
- Monitorare Dell dispositivi
- Avvio di Dell console specifiche del dispositivo
- Informazioni sulla garanzia per i dispositivi Dell
- Rimozione di Dell dispositivi
- Messaggi Knowledge base (KB) per gli alert generati
- Risoluzione dei problemi
- Domande frequenti
- Appendix
Identifier GUID-00221440-BBDC-4C54-B6E0-5BA43BD3403F
Version 2
Status In translation
Appendix
Configuring SNMP parameters for iDRAC using the iDRAC
web console
1. Launch the iDRAC (12th and later generation of Dell PowerEdge servers) web console and navigate to Network > Services in the
console.
2. Configure the SNMP Agent properties:
a. Set Enabled to True and SNMP Protocol to All (SNMP v1/v2/v3).
b. Set SNMP Community Name with a community string.
c. Click Apply to submit the configuration.
N.B.: The Plug-in communicates with iDRAC using only SNMP v1 or SNMP v2 protocol.
Configuring SNMP parameters for iDRAC using RACADM
script
1. Launch the iDRAC RACADM CLI by running the following ssh command:
ssh root@<iDRAC IP>
2. Change the command mode to racadm by running the following command:
racadm
3. Set the SNMP community string by running the following command:
racadm set idrac.SNMP.AgentCommunity <community string>
4. Enable the SNMP agent by running the following command:
racadm set idrac.SNMP.AgentEnable 1
(Values: 0 – Disabled, 1 – Enabled)
5. Set the SNMP protocol to All by running the following command:
racadm set idrac.SNMP.SNMPProtocol 0
(Values: 0 – All, 1 – SNMPv3)
6. Verify the configuration by running the following command:
racadm get idrac.SNMP.Alert
A
42 Appendix