Users Guide
Table Of Contents
- Dell OpenManage Plug-in Version 1.0 for Nagios Core User’s Guide
- Contents
- Introduction to Dell OpenManage Plug-in Version 1.0 for Nagios Core
- Support matrix
- Device Discovery and Inventory
- Monitor Dell Devices
- Launching iDRAC Web Console
- Removing Dell Devices
- Troubleshooting
- Frequently Asked Questions
- Appendix
install.sh trap
4. Once the trap integration is complete, restart the SNMPTT service, run the command:
service snmptt restart
The Dell OpenManage Plug-in specific services are
displaying the message, “Error while creating SNMP
Session”
1. The recommended versions of Net-SNMP and Net-IP are installed. If you are using IPv6, then the Perl module Socket6
should also be installed.
2. The IP addresses or hosts provided are reachable.
3. SNMP is enabled on the IP addresses or hosts.
4. The appropriate SNMP parameters are correctly configured in the following files:
dell_resource.cfg
.dell_device_comm_params.cfg
Dell OpenManage Plug-in specific services are displaying
the message, “WSMAN Error while communicating with
host”
1. OpenWSMAN and its perl binding and Net-IP are installed.
2. The IP addresses or hosts provided are reachable.
3. The appropriate WS-MAN parameters are correctly configured in the following files:
dell_resource.cfg
.dell_device_comm_params.cfg
Dell OpenManage Plug-in specific services are
displaying the message, “Component Information =
UNKNOWN”
NOTE: This is an expected message if the component is not available in the discovered Dell device.
If the component is available and you are still receiving the message, then this message is due to protocol time-out. Set the
required protocol specific time-out values in the .dell_device_comm_params.cfg file.
22
Troubleshooting