Setup Guide
Table Of Contents
- Dell EMC OpenManage HPE OMi Operations Connector Version 1.0 Installation Guide
- Introduction
- Installation prerequisites
- Downloading and installing the Dell EMC OpenManage HPE OMi Operations Connector
- Post installation
- Repairing the Dell EMC OpenManage HPE OMi Operations Connector
- Uninstalling the Dell EMC OpenManage HPE OMi Operations Connector
- Accessing support content from the Dell EMC support site
Post installation
Once you have successfully installed the Operations Connector for OME, you must perform the steps listed below:
1. Configuring OME connection parameters for Operations Connector
2. Configuring the task scheduler parameters
3. Activating the Dell EMC OpenManage HPE OMi Operations Connector policies
4. Creating a custom view in the HPE Operations Manager i console
5. Configuring the OME URL tool in the HPE Operations Manager i console
Topics:
• Configuring OME connection parameters for Operations Connector
• Configuring the task scheduler parameters
• Activating the Dell EMC OpenManage HPE OMi Operations Connector policies
• Creating a custom view in HPE Operations Manager i console
• Configuring the OME URL tool in HPE Operations Manager i console
Configuring OME connection parameters for
Operations Connector
After installing the Operations Connector for OME, you need to configure OpenManage Essentials (OME) connection
parameters using the configuration utility.
To configure the OME parameters such as OME host name, domain name, user name, password, and port number, perform the
following steps:
1. On the HPE Operations Connector server, navigate to %OvDataDir%\conf\DellEMCBsmIntOME\scripts.
NOTE:
<OvDataDir> is the data directory of HPE Operations Agent. The <OvDataDir> default value for the
Windows operating system is C:\ProgramData\HP\HP BTO Software.
2. Run the following command line arguments as a local administrator:
Table 2. OME connection parameters for Operations Connector
Parameters Syntax Description
OME Host Name configureBsmconnectorForOME.bat -
setomehostname
This command is used to configure the
IPv4 address or hostname of the host
where the OME is installed.
For example:
● IPv4 address as 100.100.28.66
● Host name as omeserver
OME User Name configureBsmconnectorForOME.bat -
setomeuser
This command is used to configure
the user name credential used for
communicating with OME host name that
you provided while configuring OME host
name.
Ensure that the user is either a valid
Windows local/admin user of OME or a
part of the same active directory domain
as OME.
4
Post installation 7