Setup Guide
Table Of Contents
- Dell EMC OpenManage HPE OMi Operations Connector Version 1.0 Installation Guide
- Introduction
- Installation prerequisites
- Downloading and installing the Dell EMC OpenManage HPE OMi Operations Connector
- Post installation
- Repairing the Dell EMC OpenManage HPE OMi Operations Connector
- Uninstalling the Dell EMC OpenManage HPE OMi Operations Connector
- Accessing support content from the Dell EMC support site
Installation prerequisites
The requirements for installing the Dell EMC OpenManage HPE OMi Operations Connector are as follows:
● Ensure that you have local administrator privilege on the HPE Operations Connector server.
● Ensure that minimum of 10 GB hard disk space must be available on the HPE Operations Connector server.
● Ensure that you meet the software requirements listed in the table below:
Table 1. Software requirements
Components Supported Version Supported operating systems
HPE Operations Manager i (OMi) 10.12
● Windows Server 2012 R2 Datacenter Edition (64-bit)
● Windows Server 2012 Datacenter Edition (64-bit)
NOTE: ESXi running the supported versions of the Windows
guest operating systems is also supported.
HPE Operations Connector 10.11
Dell EMC OpenManage Essentials
(OME)
2.2 and 2.3 See the OpenManage Essentials Versions 2.2 and 2.3 Support
Matrix available at Dell.com/openmanagemanuals.
NOTE: It is recommended that you install OME and HPE Operations Connector on separate host systems.
Topics:
• Supported devices
Supported devices
The Dell EMC OpenManage HPE OMi Operations Connector supports all the Dell EMC devices that are supported by
OpenManage Essentials (OME). For detailed information about the supported Dell EMC devices, see the OpenManage
Essentials Versions 2.2 and 2.3 Support Matrix at Dell.com/OpenManageManuals.
2
Installation prerequisites 5