Users Guide

2. Click Delete Image.
3. Click Delete to confirm.
4. The system displays delete image is success.
Replace switch in a fabric
You can replace the faulty OS10 switch in a fabric. To replace:
1. Identify the OS10 switch to be replaced and label each of the cables with the port numbers before disconnecting the cables.
2. Back up the following configurations from the faulty switch to configure the new switch with the same details:
● Hostname
● Management IP address
● DNS and NTP IP addresses if configured
● Spanning-tree mode
NOTE: In SmartFabric Services mode, RPVST+ is enabled by default on the uplink interfaces.
● Other nonfabric commands
3. Ensure that the new switch has the same OS version as the faulty switch. You can check the version using the following
command:
OS10# show version
4. Power off the existing switch to prevent data traffic loss in the cluster.
5. Remove the ICL and uplink connections from the existing switch, and connect to the new switch.
Lifecycle management
137