Users Guide

Configure networks and routing configuration
You can set up networks and routing configuration.
NOTE: Networks that are created by the OMNI user interface are considered Manual.
The OMNI vCenter PortGroup VLAN automation process does not add Manual networks to auto uplinks, and does not remove
them from SmartFabric. Add Manual networks to uplinks using the OMNI portal if needed. The OMNI VLAN automation process
uses Manual networks for ServerInterfaces. If you are using the VLANs for the OMNI registered vCenter PortGroup, it
is not recommended to use the OMNI portal to create a network. OMNI automation manages those VLANs or networks by itself.
For complete information, see OMNI vCenter integration.
You can configure three types of networks including VXLAN networks (for L2 and L3 profiles), VLAN networks (for L2 and L3
profiles), and L3 routed interfaces (for L3 profiles only).
View Networks summary
Select the Service Instance, and click Network.
Configure networks
You can manage VXLAN and VLAN networks, and L3 routed interfaces.
VXLAN network
From Network tab, you can create, edit, and delete VXLAN and VLAN networks, and L3 routed interfaces.
Create VXLAN network
Virtual network for L2 profile:
1. Select Network from the Network tab, then click Networks > VxLAN Networks. The page displays the list of the VXLAN
networks that are configured in the service instance.
104
OMNI SmartFabric Management