Users Guide
Table Of Contents
- OpenManage Network Integration for SmartFabric Services User Guide Release 2.0
- Change history
- Overview of OMNI, SFS, VxRail, and PowerEdge MX
- SmartFabric Services
- OpenManage Network Integration
- OMNI vCenter integration
- Access the OMNI stand-alone portal
- Access the OMNI Fabric Management Portal
- OMNI Appliance Management user interface
- OMNI automation support for PowerEdge MX SmartFabric
- OMNI automation support for NSX-T
- OMNI support for SmartFabric instances
- Lifecycle management
- Troubleshooting
- Logs and support data for troubleshooting
- Verify OMNI VM connectivity
- Unable to add SmartFabric instance in OMNI
- Missing networks on server interfaces
- Unable to launch OMNI UI
- OMNI plug-in does not show service instance
- Unable to register the vCenter in OMNI
- OMNI is unable to communicate with other devices
- Timestamp not synchronized in OMNI
- Reset OMNI VM password
NOTE: Alternatively, you can also log in to Fabric Management portal directly using https://
OMNI_IP
/
delawareos10 with the configured IP address or FQDN.
After successful authentication, OMNI Home page is displayed.
Once you log in to the OMNI Fabric Management Portal with the username and password, OMNI Home page is displayed.
As an initial step, you must configure OMNI IP address or FQDN first to proceed with any other configuration in OMNI, see
Configure OMNI. After configuring OMNI IP address or FQDN, from OMNI Home, you can:
● Add, edit, or delete SmartFabric instance, see here.
● Add, edit, or delete NSX-T instance, see here.
● Add, edit, or delete OME-Modular, see here.
● Add, edit, or delete vCenter instance, see here.
● View relationship details.
● View OMNI information.
Configure OMNI
If you are logging in to OMNI for the first time, after reaching OMNI Home page, configure OMNI first. You cannot use other
features of OMNI until you set the OMNI IP address or FQDN.
1. From OMNI Home > OMNI Configuration, click Set OMNI Address.
54
Access the OMNI stand-alone portal