Users Guide
Table Of Contents
- OpenManage Network Integration for SmartFabric Services User Guide Release 2.0
- Change history
- Overview of OMNI, SFS, VxRail, and PowerEdge MX
- SmartFabric Services
- OpenManage Network Integration
- OMNI vCenter integration
- Access the OMNI stand-alone portal
- Access the OMNI Fabric Management Portal
- OMNI Appliance Management user interface
- OMNI automation support for PowerEdge MX SmartFabric
- OMNI automation support for NSX-T
- OMNI support for SmartFabric instances
- Lifecycle management
- Troubleshooting
- Logs and support data for troubleshooting
- Verify OMNI VM connectivity
- Unable to add SmartFabric instance in OMNI
- Missing networks on server interfaces
- Unable to launch OMNI UI
- OMNI plug-in does not show service instance
- Unable to register the vCenter in OMNI
- OMNI is unable to communicate with other devices
- Timestamp not synchronized in OMNI
- Reset OMNI VM password
3. Select 2. View OMNI management service status to view the list of registered vCenter managed by the OMNI VM.
Confirm that all services are active.
NOTE: View OMNI management service status is recommended for status validation and debugging purpose.
Hence, the output does not show the port numbers.
OMNI plug-in does not show service instance
Problem
OMNI plug-in does not show any service instance even though the service instance is added to OMNI.
OMNI plug-in does not show the instance when the vCenter is launched using the IP address but the vCenter is registered with
FQDN in OMNI.
Cause
This problem can happen when the DNS is either not reachable or not configured with required settings.
Resolution
Ensure that the DNS is reachable, and configured with forward and reverse lookup for vCenter IP address or FQDN.
Unable to register the vCenter in OMNI
Problem
Unable to register the vCenter in OMNI.
Causes
186
Troubleshooting