Users Guide
Table Of Contents
- OpenManage Network Integration for SmartFabric Services User Guide Release 2.0
- Change history
- Overview of OMNI, SFS, VxRail, and PowerEdge MX
- SmartFabric Services
- OpenManage Network Integration
- OMNI vCenter integration
- Access the OMNI stand-alone portal
- Access the OMNI Fabric Management Portal
- OMNI Appliance Management user interface
- OMNI automation support for PowerEdge MX SmartFabric
- OMNI automation support for NSX-T
- OMNI support for SmartFabric instances
- Lifecycle management
- Troubleshooting
- Logs and support data for troubleshooting
- Verify OMNI VM connectivity
- Unable to add SmartFabric instance in OMNI
- Missing networks on server interfaces
- Unable to launch OMNI UI
- OMNI plug-in does not show service instance
- Unable to register the vCenter in OMNI
- OMNI is unable to communicate with other devices
- Timestamp not synchronized in OMNI
- Reset OMNI VM password
1. Select the fabric uplink from the list, and click Edit Ports.
2. Edit the networks associated with uplink interfaces, and click Update.
3. The system displays the uplink interface edit success message.
Delete an uplink
You can delete a user-created uplink. To delete:
1. Select the uplink from the displayed list, and click Delete.
2. Click Delete to confirm.
Configure networks and routing configuration
You can set up networks and routing configuration.
NOTE: Networks that are created by the OMNI user interface are considered Manual.
OMNI support for SmartFabric instances 135