Deployment Guide

All services must be active. If they are not all active, restart the service by selecting 4. Restart SmartFabric Management Service.

Confirm that the error is resolved.

2. Confirm the password that is supplied during registration is correct. If not correct, reregister the plug-in to update the SmartFabric

password on the appliance.

Configure NTP server

NOTE: If the NTP server is not configured, the SmartFabric vCenter appliance VM will not synchronize with the data

center.

1. Select 2. Interface Configuration Menu.

2. Select 5. Configure NTP Server.

3. Enter the Validate NTP Server IP address/host name.

NTP server status

1. Select 2. Interface Configuration Menu.

2. Select 4. Show NTP Server.

Troubleshooting