Deployment Guide

4. Select breakout mode, then click Submit.
Jump port
This information describes jump port operations. Only one port per switch can be configured as a jump port. You can select any available
port that is not part of an uplink or intercluster link, or connected to an ESXi server which is part of SmartFabric deployment.
If you would like to change an existing jump port, you must unconfigure it, then add the new jump port. Removing a jump port makes the
port available for all traffic, and can be connected to a VxRail switch.
Add new jump port
1. Select SmartFabric vCenter, then select SmartFabric.
2. Select the specific SmartFabric instance, select Configure, then select Jump Port.
3. Select the switch, select the interface, then click Add Jump Port.
4. Enter the VLAN description, then click Add.
Reconfigure jump port
System management
51