Users Guide

Figure 26. Adding multiple iDRACs

The process of adding multiple iDRACs is initiated. You can check the status of the process in the Task Manager.

Adding an iDRAC using iDRAC Quick Sync Read

The iDRAC Quick Sync Read feature enables your mobile device to act as a proximity reader. It reads data from your server when the

device is in contact with the iDRAC Quick Sync bezel.

NOTE:

• Dell EMC recommends upgrading your iDRAC firmware to the latest version. For more information about upgrading

the iDRAC firmware see the,

iDRAC User Guide

• This feature is applicable only for the 13th generation of PowerEdge servers with the iDRAC Quick Sync bezel.

• Reading iDRAC information using Quick Sync is not password that is protected. Making configuration changes using

iDRAC Quick Sync requires iDRAC credentials with appropriate permission.

To add an iDRAC using iDRAC Quick Sync Read:

1. Start OpenManage Mobile.

2. If applicable, type the OMM Password and tap Login.

The OMM home page is displayed.

3. Perform one of the following:

• On the OMM home page, tap Connect

•

On the OMM home page, tap View All, and tap in the upper right corner.

4. Tap Server, and tap Next.

5. Tap Add via Quick Sync, and tap Next.

6. Tap Launch iDRAC Quick Sync.

Managing iDRAC