Users Guide

• Hardware Inventory

• License Information

• Software Inventory

• Job Information

• Custom Command

Performing RACADM Command operations

Ensure the device is connected to the appropriate server and network.

NOTE: The RACADM commands can also be performed via WSMAN or Quick Sync over WiFI.

To perform RACADM command operations:

1. From the Home screen, tap the appropriate server.

2. Tap Options.

3. Tap Run RACADM command.

The RACADM commands screen is displayed.

4. Tap one of the following commands mentioned below:

• System Information

• Hardware Inventory

• License Information

• Software Inventory

• Job Information

• Custom Command - You can manually type a RACADM command to perform any server operation.

The available report is displayed.

Figure 26. RACADM Commands

Device inventory

You can view the following device inventory information of a server (iDRAC connection) or an OpenManage Essentials — managed

device.

Table 1. Device inventory

Information Description

Power State Displays the power status of the device

IP Address If this server was added individually, this value is the IP address used to connect to the iDRAC. If this device is

discovered through OpenManage Essentials, there could be multiple IP addresses associated with the device

Managing iDRAC 29