Users Guide
• Reboot the Appliance
2. To confirm the current appliance administrator password, select Change the Admin Password, and then provide the password.
Press Tab and select Continue.
3. On the TUI screen:
a) To view appliance status and the IPv4 and IPv6 statuses and addresses, select Current Appliance Status.
b) To configure network interface, select Set Networking Parameters.
On the Configure Network Interface screen, to enable IPv4, or IPv6, or both, press Enter. Select Apply.
NOTE: To perform any write operations on TUI, ensure that you type the admin password, and then configure
IPv4 or IPv6.
NOTE: To configure IPv6, ensure that it is already configured by vCenter server.
c) To enable console debug, select Enable Field Service Debug (FSD) Mode. See Field service debug workflow.
d) To restart OpenManage Enterprise–Tech Release, select Reboot the Appliance.
Configuring OpenManage Enterprise–Tech
Release
If you are logging in to OpenManage Enterprise–Tech Release for the first time, the Welcome to OpenManage Enterprise page is
displayed. To configure the basic settings, click Initial Settings, and type or select the following data in the dialog box:
1. From the Time Zone drop-down menu, select a time zone. Click Apply to save the selected time zone. To set the time zone to a
default value, click Discard. After updating the time zone, all active users are logged out of OpenManage Enterprise–Tech Release.
2. If you want to use the NTP Server for time synchronization, select the Use NTP Server check box.
NOTE:
When the NTP Server settings are updated, the currently logged in users are automatically logged out from
their OpenManage Enterprise–Tech Release sessions.
3. Type the IP address or hostname in Primary NTP Server Address and Secondary NTP Server Address (optional) for time
synchronization.
4. If you want to set proxy server for external communication, select the Use HTTP Proxy Settings check box.
5. In the Server IP Address box, enter the IP address or host name for the proxy server.
6. In the Port box, enter the port number for the proxy server.
7. If the proxy server requires credentials to log in, select the Use Proxy Credentials check box, enter the user name and password.
8. Click FINISH.
NOTE:
For information about supported browsers, see the
OpenManage Enterprise–Tech Release Support Matrix
available on the support site.
Supported protocols and ports in OpenManage
Enterprise–Tech Release
• See Supported protocols and ports on managed nodes.
• See Supported protocols and ports on management stations.
Supported protocols and ports on management stations
Table 5. OpenManage Enterprise–Tech Release supported protocols and ports on the management stations
Port Number Protocol Port Type Maximum
Encryption Level
Direction Usage
21 FTP TCP 256-bit In/Out Access dell.com
22 SSH TCP 256-bit In/Out Required for incoming only if FSD is used.
OpenManage Enterprise–Tech Release
administrator must enable only if interacting with
the Dell EMC support staff.
Getting started with OpenManage Enterprise–Tech Release 13