Release Notes

Description: : The rollback features is not supported on the MX7000 chassis. Also, the rollback operation fails on the M1000e, FX2, and
FX2s chassis. [110239]
Resolution: For M1000e, FX2, and FX2s chassis, create and associate a new baseline with the necessary firmware version to roll back.
Issue 16
Description: Currently, the alerts are not received by OpenManage Enterprise if the alerts are associated with the devices' IP address.
However, alerts are successfully received when associated with the device Service Tag. [106369]
Issue 17
Description: Invalid host names are displayed under the Source Name column and are also available for selection in some of the
OpenManage Enterprise tasks. [68214]
Issue 18
Description: In OpenManage Enterprise version 3.0, authentication by one-way and two-way trusts of AD users is not supported.
Issue 19
Description: From the All Devices page, you cannot launch the iDRAC application interface with IPv6 addresses. [102153]
Issue 20
Description: When PCIe cards are mapped to the FX2/FX2s chassis, migration of identities are not supported on the sleds in the same
FX2s chassis since the FQDDs differ.
Installation
Dell EMC OpenManage Enterprise is provided as an appliance that you can deploy on a hypervisor and manage resources to minimize
downtime. The virtual appliance can be configured from the application web console after initial network provisioning in the Text User
Interface (TUI). For steps to view and update the console version, see the Dell EMC OpenManage Enterprise User's Guide on the support
site.
NOTE:
For information about supported browsers, see the OpenManage Enterprise Support Matrix available on the support
site.
Installation prerequisites and minimum requirements
For a list of supported platforms, operating systems, and browsers, see the Dell EMC OpenManage Enterprise Version 3.0 Support Matrix
on the support site and Dell TechCenter.
To install OpenManage Enterprise, you must have the local system administrator rights and the system you are using must meet the
criteria. See the Dell EMC OpenManage Enterprise User's Guide on the support site and Dell TechCenter.
Recommended minimum hardware configuration for OpenManage Enterprise version 3.0:
Table 1. Minimum recommended hardware
Minimum recommended hardware Large deployments Small deployments
Number of devices that can be managed
by the appliance
Up to 8000 1000
RAM 16 GB 16 GB
Processors 8 cores total 4 cores total
Hard drive 200 GB 20 GB
Dell EMC OpenManage Enterprise Version 3.0 Release Notes 5