Release Notes

Description: Discovery operation fails by using IPMI commands on the CISCO server if a KG key is used. [78545]

Resolution: KG key is not supported for this device discovery.

Issue 21

Description: When a device is turned off, the console takes a few moments to display the updated health status. [86146]

Resolution: Refresh the browser or wait for a few moments.

Issue 22

Description: An individual Chassis Management Controller (CMC) health may not be correctly displayed in the device drill-down operation.

[85977]

Resolution: Always consider the CMC rollup health status.

Issue 23

Description: Certain SNMP alerts are undefined for the S4810 networking switch. [85016]

Resolution: N/A

Issue 24

Description: An unknown Error message occasionally displayed in the SNMP alert console. [84894]

Resolution: Ignore or click Dismiss.

Issue 25

Description: In the SNMP alert console, some alerts from OMSA correctly show the Message ID field, while others show N/A. [83579]

Resolution: N/A

Issue 26

Description: Discovery of an HP server by using IPMI command may not reflect the correct rollup health status. [85153]

Resolution: View the lower level sensor health data.

Installation

Dell EMC OpenManage Enterprise–Tech Release is provided as an appliance that you can deploy on a hypervisor and manage resources

to minimize downtime. The virtual appliance can be configured from the application web console after initial network provisioning in the

Text User Interface (TUI). For steps to view and update the console version, see the Dell EMC OpenManage Enterprise–Tech Release

User's Guide on the support site.

NOTE:

For information about supported browsers, see the

OpenManage Enterprise–Tech Release Support Matrix

available on

the support site.

Installation prerequisites and minimum requirements

For a list of supported platforms, operating systems, and browsers, see the Dell EMC OpenManage Enterprise–Tech Release Support

Matrix on the support site and Dell TechCenter.

To install OpenManage Enterprise–Tech Release, you must have the local system administrator rights and the system you are using must

meet the criteria. See the Dell EMC OpenManage Enterprise–Tech Release User's Guide on the support site and Dell TechCenter.

Recommended minimum hardware configuration for OpenManage Enterprise–Tech Release:

Small (up to 1000 managed systems):

• Processor: 4 cores

• RAM: 8 GB

• Hard drive: 20 GB

Large (up to 5500 managed systems):

• Processor: 8 cores

• RAM: 16 GB

• Hard drive: 200 GB

Dell EMC OpenManage Enterprise–Tech Release Release Notes