Release Notes

Known issues

Discovery and inventory

Issue 1

Description: Discovery of Windows server(s) using non-admin credentials fails with an error message 'Unable to connect to the device

over SSH because a connection error occurred.' This must be interpreted instead as 'Unable to perform the requested action because the

device management endpoint authentication over SSH failed'. [158088]

Issue 2

Description: The Guest information for the discovered Hyper-V 2012 R2 servers is not available on the device's Hardware page. [159535]

Issue 3

Description: The correlation of Windows Hyper-V post MX7000 chassis CCD, fails to give the Guest VM information under Device details

page. [167935]

Resolution: The sled discovery need to be done out of the MX7000 chassis and managed separately to view the guest details.

Issue 4

Description: Server-initiated discovery is not triggered automatically in the appliance when a port-change announcement is received.

[167662]

Issue 5

Description: The Managed State of the previously 'Monitored' MX7000 chassis and sleds, on the All Devices page, is incorrectly displayed

as 'Managed' post their rediscovery using the same lower privilege local or AD/LDAP credentials (Viewer or Device Manager) as before.

[152154]

Issue 6

Description: If the SNMP trap destination is manually set in iDRAC as OpenManage Enterprise, the alerts are received and processed by

the appliance. However, the device's Managed State displayed on the All Devices page remains the same as its initially discovered state of

'Monitored,' 'Managed,' or 'Managed with Alerts.' [158992]

Issue 7

Description: For the Multi-Chassis Management (MCM) group, a Chassis Refresh Inventory task for the 'lead' chassis does not fully

update the sled inventory. A Chassis Refresh Inventory task is triggered in the appliance when a sled is removed from the lead chassis and

added to a member chassis. [165191]

Resolution: To immediately update the sled inventory, trigger the refresh inventory of the sled manually. Otherwise, the sled inventory

will be refreshed during the automatic daily inventory collection.

Issue 8

Description: All the existing firmware compliance tasks will refresh automatically post device discovery. [146981]

Issue 9

Description: The management IP on the Device Details page of the discovered VxRail devices does not match the management IP

displayed on the All Devices page. [91653]

Issue 10

Description: If the onboarding state of the lead chassis and member chassis in an MCM group is in monitored state, the inventory task

might fail if the MCM group is configured with more than 10 chassis. [108962]

Issue 11

Description: The exported inventory file lists values for component status and URL of the chassis is not listed. [108056]

Issue 12

Description: Servers that are reconfigured as VxRAIL do not automatically group under HCI upon refreshing the inventory. [116913]

Resolution: After a server is reconfigured as a VxRAIL, rediscover the device in the Discovery page. After rediscovery, the device is

correctly grouped under HCI.

Issue 13

Description: The All Devices page shows health status of the discovered YX1X servers with iDRAC firmware version 1.98 or later as

unknown.

Issue 14