White Papers

Set up Auto-Deploy Configuration
7 Auto-Deploy Provisioning on Servers or Chassis Using DellEMC OpenManage Enterprise 3.2 | Technical white
paper
2.2 Set up an Auto-Deploy configuration using a template and device
service tags:
Below are the steps to create auto-deployment configuration using the Auto Deploy wizard:
1. Go to the Auto Deploy page by clicking Configuration  Auto deploy.
2. Click Create to start the Auto Deploy Template wizard.
3. Select the Template Type from either server or chassis.
4. Select a template from the drop-down list (only templates captured in the Deploy portal will be listed).
Note:
• Templates seen in the drop-down list depend on your Template Type selection. If the template type is
selected as server, only server templates will be displayed and if the selection was chassis then only
chassis templates will be displayed.
• If the template captured has identity attributes, a warning message is displayed to associate the
identity pool. (Optionally, if the identity pool is associated, then the virtual network addresses will be
deployed else virtual network address will not be deployed on target.)
Figure 2: Auto deploy template wizard
5. Click Next. Target Information page is displayed.
6. A service tag or node id can be directly entered in following format:
• A) Manually – you can choose to enter the service tags or node ids manually.