Users Guide

5. In the iSCSI section:
a) Select the Include iSCSI MAC addresses check box to include iSCSI MAC addresses.
b) Enter the starting MAC address and specify the number of iSCSI MAC addresses to be created.
c) Select Configure iSCSI Initiator, and then enter the IQN prefix.
d) Select Enable iSCSI Initiator IP Pool, and then enter the network details.
NOTE: The iSCSI Initiator IP Pool does not support IPv6 addresses.
6. In the FCoE section:
a) Select the Include FCoE Identity check box to include FCoE identities.
b) Enter the starting MAC address and specify the number of FCoE identities to be created.
NOTE: The WWPN and WWNN addresses are generated by prefixing 0x2001 and 0x2000 respectively to the MAC
addresses.
7. In the Fibre Channel section:
a) Select the Include FC Identity check box to include FC identities.
b) Enter the postfix octets (six octets) and the number of WWPN and WWNN addresses to be created.
NOTE: The WWPN and WWNN addresses are generated by prefixing the provided postfix with 0x2001 and
0x2000 respectively.
The identity pool is created and is listed under the Identity Pools tab.
Create Identity Pool - Fibre Channel
You can add Fibre Channel (FC) addresses to the identity pool. The FC comprises of WWPN/WWNN addresses.
Include FC
Identity
Select the check box to add FC addresses to the identity pool.
Postfix (6 octets) Enter the postfix in one of the following formats:
• AA:BB:CC:DD:EE:FF
• AA-BB-CC-DD-EE-FF
• AABB.CCDD.EEFF
The length of the postfix can be a maximum of 50 characters. This option is displayed only if the Include FC
Identity check box is selected.
Number of
WWPN/WWNN
Addresses
Select the number of WWPN or WWNN address. The address can be between 1 and 5000.
This option is displayed only if the Include FC Identity check box is selected.
Actions
Previous
Displays the FCoE tab.
Finish Saves the changes and displays the Configuration page.
Cancel Closes the Create Identity Pool wizard without saving the changes.
Create Identity Pool - iSCSI
You can configure the required number of iSCSI MAC addresses in the iSCSI tab.
NOTE: The iSCSI attributes are applied only when the DHCP option for iSCSI Initiator is disabled in the source template.
Include iSCSI MAC
Addresses
Select the check box to add the iSCSI MAC addresses to the identity pool.
Starting MAC
Address
Enter the starting MAC address of the identity pool in one of the following formats:
Manage device configuration templates 49