Users Guide

7. Click Finish. The firmware version is rolled back.
NOTE: Currently, the Rollback feature tracks only the version number from which the firmware is rolled back. Rollback
does not consider the firmware version that is installed by using the Rollback feature (by rolling back the version).
Export the single device inventory
You can export inventory data of only one device at a time to only the .csv format.
1. In the left pane, select the device group. A list of devices in the group is displayed in the Devices list.
A Donut chart indicates the device status in the working pane. See Donut chart. A table lists the properties of devices
selected. See Device list.
2. In the devices list, select the check box corresponding to the device, and then click Export Inventory.
3. In the Save As dialog box, save to a known location.
NOTE: When exported to .csv format, some of the data displayed on the GUI is not enumerated with a descriptive
string.
Performing more actions on chassis and servers
By using the More Actions drop-down menu, you can perform the following actions on the All Devices page. Select the
device(s) and click any one of the following:
● Turn LED On: Turn on the LED of the device to identify the device among a group of devices in a data center.
● Turn LED Off: Turn off the LED of the device.
● Power On: Turn on the device(s).
● Power Off: Turn off the device (s).
● Graceful Shutdown: Click to shut down the target system.
● Power Cycle System (Cold Boot): Click to power off and then restart the system.
● System Reset (Warm Boot): Click to shut down and then reboot the operating system by forcefully turning off the target
system.
● Proxied: Displayed only for the MX7000 chassis. Indicates that the device is discovered through an MX7000 lead chassis in
case of Multi-Chassis Management (MCM).
● IPMI CLI: Click to run an IMPI command. See Create a Remote command job for managing devices on page 128.
● RACADM CLI: Click to run a RACADM command. See Create a Remote command job for managing devices on page 128.
● Update Firmware: See Update the device firmware and drivers by using baselines on page 61.
● Onboarding: See Onboarding devices on page 43.
● Export All and Exported Selected: See Export all or selected data on page 63.
Hardware information displayed for MX7000 chassis
● Chassis Power Supplies—Information about the Power Supply Units (PSUs) used in the sleds and other components.
● Chassis Slots—Information about the slots available in the chassis and components, if any, installed in slots.
● Chassis Controller—The Chassis Management Controller (CMC) and its version.
● Fans—Information about the fans used in the chassis and its working status.
● Temperature—Temperature status and threshold values of chassis.
● FRU—Components or Field Replacable Units (FRUs) that can are installed in the chassis.
Export all or selected data
You can export data:
● About the devices you view in a device group and perform strategic and statistical analysis.
● About a maximum of 1000 devices.
● Related to system alerts, reports, audit logs, group inventory, device list, warranty information, Support Assist, and so on.
● Into the following file formats: HTML, CSV, and PDF.
NOTE:
Manage devices and device groups 63