Users Guide

2. Select the check box corresponding to the device(s), and then click Refresh Health on Group.
A job is created and listed in the Jobs list and identified as New in the JOB STATUS column.
The latest working status of selected device(s) is collected and displayed on the Dashboard and other relevant sections of
OpenManage Enterprise. To download a device inventory, see Export the single device inventory on page 63.
Related information
Organize devices into groups on page 52
Refresh health on devices
By default, the health of all the devices and device groups is refreshed automatically by the appliance on an hourly basis,
however, you can also refresh the health of device(s) and/or device group(s) at any moment . The following steps describe how
to refresh health and online status on the selected devices on the All Devices page.
NOTE:
● To perform any tasks on OpenManage Enterprise, you must have necessary role-based user privileges and scope-based
operational access to the devices. See Role and scope based access control in OpenManage Enterprise on page 15.
● For the in-band devices discovered using the ESXi and Linux operating systems, the Health State ( ) is displayed as
Unknown ( ).
1. Go to the All Devices page by clicking OpenManage Enterprise > Devices.
2. Select the devices from the Devices list on which you want to refresh the health.
3. Click the Refresh Health drop-down menu and then click Refresh Health on Devices.
A Health task is initiated for the selected devices. You can view the status of the health task on the Jobs page (OpenManage >
Monitor > Jobs).
Roll back an individual device's firmware version
You can roll back the firmware version of a device that is later than the firmware version of the baseline it is associated with.
This feature is available only when you view and configure properties of an individual device. See View and configure individual
devices on page 64. You can upgrade or roll back the firmware version of an individual device. You can roll back the firmware
version of only one device at a time.
NOTE:
● Rollback is applicable only for firmware. Device drivers once updated, can't be rolled back to previous version.
● Rollback is only for devices that are updated from the OME console (it is applicable to both baseline and for single DUP
update).
● If any of the installed iDRACs are not in 'ready' state, a firmware update job may indicate failure even though the
firmware is successfully applied. Review the iDRAC that is not in the ready state, and then press F1 to continue during
the server boot.
Any device firmware that is updated by using the iDRAC GUI is not listed here and cannot be updated. For information about
creating baseline, see Create a firmware/driver baseline on page 76.
1. In the left pane, select the group, and then click the device name in the list.
2. On the <device name> page, click Firmware/Drivers.
3. From the Baseline drop-down menu, select the baseline to which the device belongs to.
All the devices that are associated with the selected baseline are listed. For information about field description in the table,
see View the baseline compliance report on page 78.
4. Select the check box corresponding to the device whose firmware version must be rolled back which is identified by
.
5. Click Rollback Firmware.
6. In the Rollback Firmware dialog box, the following information is displayed:
● COMPONENT NAME: Component on the device whose firmware version is later than the baseline version.
● CURRENT VERSION: Current version of the component.
● ROLLBACK VERSION: Suggested firmware version to which the component can be downgraded.
● ROLLBACK SOURCE: Click Browse to select a source from where the firmware version can be downloaded.
62
Manage devices and device groups